• Biotechnology: enzymes, how they work and how industry uses them

How do you measure enzyme activity?

Written with AI (How we create content)Target level: Grade 11Last updated: Report an error
Quick answer

You measure enzyme activity as a rate: how much product the enzyme makes, or substrate it uses, per minute. A substrate that turns colored is followed in a spectrophotometer, a standard curve turns absorbance into concentration, and the slope of the straight start of the reading gives the initial rate, written in units, micromoles per minute, under stated conditions.

The topic explained

Activity is a rate, not an amount

To measure enzyme activity is to ask how fast an enzyme works: how much product it forms, or how much substrate it uses up, in a given time. The standard measure is the enzyme unit, U: the amount of enzyme that converts one micromole of substrate per minute. Because the rate depends on temperature and pH, a unit means something only with its conditions, for example 37 °C and pH 7, and laboratories state them every time.

A common misreading is that more enzyme protein means more activity. A tube of enzyme that was heated or kept badly can hold the same milligrams and almost no activity, because a denatured enzyme has lost the shape of its active site. That is why an enzyme is sold by units, and why industry and research compare specific activity, units per milligram of protein, to judge how pure and how active a preparation is.

Making the reaction visible

Most reactions cannot be seen, so an assay uses a substrate whose product has a color. The enzyme beta-galactosidase, the lactase that splits milk sugar, also splits a colorless look-alike called ONPG into galactose and o-nitrophenol, which is yellow. The more product, the deeper the yellow.

A spectrophotometer shines light of one wavelength through the tube, here 420 nm, the blue light the yellow product absorbs most, and reports the absorbance. Within its working range, absorbance is proportional to concentration: A=εclA = \varepsilon c l, where ll is the 1 cm width of the cuvette. To turn readings into concentrations, known standards of o-nitrophenol are measured first. In our invented example they give a straight standard curve, A=0.0046cA = 0.0046c with cc in micromolar, so a reading of 0.69 means c=0.69÷0.0046=150c = 0.69 \div 0.0046 = 150 µM.

A straight standard curve of absorbance against o-nitrophenol concentration through 0 at 0, 0.23 at 50, 0.46 at 100 and 0.92 at 200 micromolar; a reading of 0.69 lies at 150 micromolar.µMabsorbance501001502000.20.40.60.80150 µM
An invented example: A = 0.0046 × concentration in µM, in a 1 cm cuvette.

The initial rate, worked through

The enzyme is added to 1 mL of ONPG at time zero and the absorbance is read every minute: 0, 0.092, 0.184, 0.276, 0.350, 0.400, 0.425. The first readings rise in equal steps, then the curve bends, because substrate runs low and product builds up. Activity is measured as the initial rate, the slope of the straight start: 0.276÷3=0.0920.276 \div 3 = 0.092 per minute.

Converted with the standard curve, that is 0.092÷0.0046=200.092 \div 0.0046 = 20 µM per minute. In 1 mL, that is 0.02 micromoles per minute, or 0.02 U. If the tube received 0.01 mg of enzyme, its specific activity is 0.02÷0.01=20.02 \div 0.01 = 2 U per mg. Students often divide the last reading by the total time instead, 0.425÷60.425 \div 6, which gives a rate nearly a quarter too low, because the reaction had already slowed.

Absorbance readings every minute from 0 to 6 minutes: 0, 0.092, 0.184, 0.276, 0.350, 0.400 and 0.425. A straight line through the first four points marks the initial rate.minutesabsorbance1234560.10.20.30.40initial rate
The curve bends as the substrate runs low; the rate is read from the straight start.

Controls make the number trustworthy

Every assay needs controls. A blank with substrate but no enzyme shows how much color appears on its own; it is subtracted from every reading. A tube with boiled enzyme shows that the activity needs the folded protein, not just its presence. Halving the enzyme should halve the initial rate; if it does not, the assay is not measuring the enzyme alone. Temperature and pH are held constant, and the reaction is stopped at the right moment with a sodium carbonate solution, which raises the pH. With these, two laboratories can compare their numbers, and a dairy can check that a batch of lactase for lactose-free milk carries the activity printed on its label, in units per gram, before the batch is used.

A table of three control tubes: a blank without enzyme shows color without enzyme; boiled enzyme shows that activity needs the folded shape; half the enzyme should halve the rate.TubeWhat is left outWhat it showsBlankthe enzymecolor without enzymeBoiled enzymeactive enzymeactivity needs shapeHalf enzymehalf the enzymerate should halve
Each control answers one question about the assay.
Free printable worksheet

Practice: measuring enzyme activity

For 11th grade biotechnology students. Use the graphs and numbers on the sheet, show every calculation, then check your answers.

Free, no sign-up. The answer key prints on the second page. Regenerating a new worksheet on the same topic needs a free account.

Free printable worksheetlessoons.com
Practice: measuring enzyme activityName:
  1. Name the product marked with a question mark and explain why the assay uses it.

    Four boxes from top to bottom, the steps of the assay, with the third box, the colored product, replaced by a question mark.ONPG (colorless)+ beta-galactosidase?read at 420 nm
  2. Define one enzyme unit, and explain why its definition must include the temperature and pH.

  3. Use the standard curve, A = 0.0046c, to find the concentration of a sample with absorbance 0.69.

    The standard curve through four standards from 0 to 200 micromolar, with a sample point labeled with its absorbance, 0.69.µMabsorbance501001502000.20.40.60.80A = 0.69
  4. From the readings 0, 0.092, 0.184 and 0.276 at 0, 1, 2 and 3 minutes, calculate the initial rate in absorbance per minute and in µM per minute.

    The progress curve of absorbance against time with its straight initial part marked by a line.minutesabsorbance1234560.10.20.30.40initial rate
  5. Why is the rate taken from the straight start of the curve and not from the last reading?

  6. Fill in the hidden cell: what does the boiled-enzyme tube show?

    A table of three control tubes with the column saying what each tube shows hidden for the boiled-enzyme row.TubeWhat is left outWhat it showsBlankthe enzymecolor without enzymeBoiled enzymeactive enzyme?Half enzymehalf the enzymerate should halve
  7. A second preparation gives an initial slope of 0.046 per minute in 1 mL with 0.01 mg of enzyme. Calculate its activity in U and its specific activity, and compare it with the first preparation, 2 U per mg.

More topics and worksheets at lessoons.com© 2026 Lessons

Common questions

What is the difference between enzyme activity and specific activity?

Activity is how much substrate the enzyme converts per minute, in units. Specific activity divides that by the milligrams of protein, so it shows how active and how pure a preparation is.

Why is absorbance measured at 420 nm in this assay?

Yellow o-nitrophenol absorbs blue light near 420 nm most strongly, so reading there gives the largest change in absorbance for each step in concentration, the most sensitive measurement.

What if a sample reads above the top standard?

Above the standards the curve may no longer be straight and the reading cannot be trusted. The sample is diluted, measured again, and the result multiplied by the dilution.

Can enzyme activity be measured without a color change?

Yes. Some assays follow a product that absorbs ultraviolet light or glows, a gas that is released, or a change in pH. The logic is the same: measure the product over time and take the initial rate.

What is a katal?

The SI unit of enzyme activity: the amount of enzyme that converts one mole of substrate per second. It is very large, so laboratories usually still use the unit of one micromole per minute.

Still have a question? Ask Lessi

Any question about this subject. Lessi answers right here, step by step.

Try asking

Asking needs a free account; your question is kept while you sign up. Answers are written by AI and can contain mistakes. Lessi doesn’t give medical or legal advice.

Learn it with a teacher

Learn this topic live with Lessi

Lessi, the AI teacher, explains it out loud on a board, with short quizzes, at your pace. The first 60 minutes are free.